Make sure to delete any temp files, the folders and anything related to UPStudio. I would also check the sd storage card on the printer. This may correct the errors you see within UPStudio, and also any IO to the printer. I would run a diagnostic to check your hard-drive/s files for errors, and also include the check for unused spaces for physical errors. UPStudio program files might be corrupt on your computer hard-drive, or the temp files UPStudio uses might be corrupt. I’m feeling a bit ignored right If somebody here has any idea what else I could test, I would much appriciate it.īest, I viewed your videos, and although I have not experienced the same events, I have a few thoughts that may help you. Jason Wu only reacted once to the inital request but never came back to me after I sent him the videos, although I send daily reminders to Please respond to my emails or this forum post. I already have opend a ticket for Tiertime Support (16546) on Jul 2. I basically can not use the printer anymore at the moment. Removed the extension board and heated bed and used the original configuration. All Pins OK, reseated all connectors + tested with multimeter. Checked all motor cables + end stop cables. “Clear Cache file” + “Clear downloaded models” in UPStudio Connecting printer via USB instead of WiFi I tried following things but nothing helped: Printer is initializing immediately after turning it on and then doing random moves… Really strange. X axis is crashing in end of axis! But it only happens sometimes, sometimes not…

“ Model Out of Print Range” in UpStudio although its clearly not! “ Motion System Error Z” in UpStudio (sometimes I also get “Motion System Error” for X and Y axis as well…) In the video you can see following problems: I made four short videos to show you the problems. I turned off the printer and wanted to see if I have better luck the next day… It always stoped at some point in the print with “ Motion System Error Z”. I had to throw away the print and start again.īut I could never finish the print (1-2 hour print time). I could not resume the print and UpStudio shows me a “ Motion System Error Z” error.

Later that day Cetus just stops in the middle of the print, drives the z axis to the top and stops. It started with the Cetus making random “beep” sounds from time to time. I even got the extension board, 24V psu, heated bed and auto probe later, all working fine.īut now since last week I got some very strange problems out of nowhere! It worked perfectly fine and produced nice prints without any fiddling around. I bought a Cetus MK3 half a year ago as my first 3D Printer.

Cetus3d model out of print range 3151